giftiger_wunsch
03-12-2008, 02:03 PM
Hi, I recently purchased a RabbitCore RCM4000 and I haven't begun developing using it yet, but I have run into a problem. For some reason, Dynamic C is unable to find the processor. I have followed all of the instructions, i.e. made sure that the chip is properly mounted on the prototyping board, made sure that the "PROG" connector is firmly secured and that the COM connector is connected securely, tried using other COM ports, etc. but Dynamic C has been unable to find the processor and as a result, I'm unable to even run the test "pong" application.
Does anyone know what else may be causing the problem?
By the way, I am currently powering the processor using a rather old 9V battery since I am in England and have as yet been unable to find another suitable power supply. It appears to be powering it sufficiently, but I certainly won't be surprised to learn that it was unable to find it because of the poor power supply :rolleyes: I can only hope this is the problem rather than something significantly more difficult to solve...
Thanks in advance for any help.
Does anyone know what else may be causing the problem?
By the way, I am currently powering the processor using a rather old 9V battery since I am in England and have as yet been unable to find another suitable power supply. It appears to be powering it sufficiently, but I certainly won't be surprised to learn that it was unable to find it because of the poor power supply :rolleyes: I can only hope this is the problem rather than something significantly more difficult to solve...
Thanks in advance for any help.