Tuurbo46
07-23-2008, 07:43 AM
Hi all,
I have just received my new LP3500 development kit, and I have followed the instructions and the "pong.c" program working fine. My next step is to get the led's flashing. At this point I have used the following path to use flashing led's:
Samples >> RCM3000 >> flashled1
At this stage nothing happens. Do I have to move any jumper setting?
Look forward to your reply.
Tuurbo46
I have just received my new LP3500 development kit, and I have followed the instructions and the "pong.c" program working fine. My next step is to get the led's flashing. At this point I have used the following path to use flashing led's:
Samples >> RCM3000 >> flashled1
At this stage nothing happens. Do I have to move any jumper setting?
Look forward to your reply.
Tuurbo46